Component Inspection (Electric Throttle Control Motor)

1. Turn ignition switch OFF.
2. Disconnect electric throttle control actuator harness connector.
3. Check resistance between electric throttle control actuator terminals as per the following.

   Electric throttle control actuator			Resistance
   Bank	Connector	Terminals
   1	F66	5 and 6	Approx. 1 - 15 Ω [at 25°C (77°F)]
   2	F64	5 and 6

   Is the inspection result normal? 

   YES: INSPECTION END

   NO: GO TO 2.

Replace malfunctioning electric throttle control actuator. Refer to "REMOVAL AND INSTALLATION ".

: INSPECTION END