Physical Values
| Terminal No. (Wire color) | Description | Condition | Value (Approx.) | ||
|---|---|---|---|---|---|
| + | - | Signal name | Input/Output | ||
| 1 (L) | - | CAN-H | - | - | - |
| 4 (R) | Ground | Rear wheel steering angle sensor (main) output voltage | Output | 4WAS rear actuator assembly turns right completely. | 4.4 V |
| 4WAS rear actuator assembly is neutral | 2.4 V | ||||
| 4WAS rear actuator assembly turns left completely. | 0.4 V | ||||
| 5 (V) | Ground | Rear wheel steering angle sensor power supply | Output | Ignition switch: ON | 5 V |
| Ignition switch: OFF | 0 V | ||||
| 7 (LG) | Ground | Rear wheel steering angle sensor (sub) output voltage | Output | 4WAS rear actuator assembly turns right completely. | 4.6 V |
| 4WAS rear actuator assembly is neutral | 2.6 V | ||||
| 4WAS rear actuator assembly turns left completely. | 0.6 V | ||||
| 8 (P) | - | CAN-L | - | - | - |
| 15 (W) | Ground | Rear wheel steering angle sensor ground | - | Always | 0 V |
| 22 (P) | Ground | Stop lamp switch | Input | Brake pedal: Depressed | Battery voltage |
| Brake pedal: Released | 0 V | ||||
| 25 (G) | Ground | 4WAS rear motor relay | Input | Ignition switch: ON | Battery voltage |
| Ignition switch: OFF | 0 V | ||||
| 27 (R) | Ground | Ignition switch | Input | Ignition switch: ON | Battery voltage |
| Ignition switch: OFF | 0 V | ||||
| 31 (W/L) | - | 4WAS communication-H | - | - | - |
| 32 (GR/V) | - | 4WAS communication-L | - | - | - |
| 34 (B/Y) | Ground | Ground | - | Always | 0 V |
| 36 (SB) | Ground | Power steering solenoid valve | Output | Vehicle speed: 0 km/h (0 MPH) (Engine speed: 400 rpm or more) | 4.4 - 6.6 V |
| Vehicle speed: 60 km/h (37 MPH) | 1.4 - 3.6 V | ||||
| 37 (L) | Ground | 4WAS rear motor power supply | Input | Ignition switch: ON | Battery voltage |
| Ignition switch: OFF | 0 V | ||||
| 38 (R) | Ground | 4WAS rear motor output voltage (right) | Output | While 4WAS rear motor activates rightward | Battery voltage |
| While 4WAS rear motor activates leftward | 0 V | ||||
| 39 (P) | Ground | 4WAS rear motor output voltage (left) | Output | While 4WAS rear motor activates rightward | 0 V |
| While 4WAS rear motor activates leftward | Battery voltage | ||||
| 40 (B/Y) | Ground | 4WAS rear motor ground | - | Always | 0 V |
CAUTION:
When using circuit tester to measure voltage for inspection, never forcibly extend any connector terminals.