LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Infiniti >> 2013 >> QX56 AWD >> Repair and Diagnosis (Single Page) >> External Pages >> Different car >> Section 329 (Power Control System (Power Distribution System) (Except CROSSCABRIOLET)) >> DTC/Circuit Diagnosis >> DTC B2615: Blower Relay Circuit >> Component Inspection
September 30: LEMON manuals is back up on a temporary server! Slowness is possible

Component Inspection

WARNING: This page is about a different car, the 2013 Nissan Murano. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK BLOWER RELAY 
    1. Turn ignition switch OFF.
    2. Remove blower relay.
    3. Check the continuity between blower relay terminals.
      Terminals Condition Continuity
      3 and 5 12 V direct current supply between terminals 1 and 2 Existed
      No current supply Not existed

      Is the inspection result normal? 

      YES: INSPECTION END

      NO: Replace blower relay. Refer to "FUSE, CONNECTOR AND TERMINAL ARRANGEMENT ".

      Fig 1: Accessory Relay Connector Terminal Identification
      G04889520Courtesy of NISSAN NORTH AMERICA, INC.
scientia non olet · About LEMON Manuals