LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Infiniti >> 2013 >> QX56 AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 249 (LAN System (Can)) >> DTC/Circuit Diagnosis >> RDR-R Branch Line Circuit >> Diagnosis Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Diagnosis Procedure

WARNING: This page is about a different car, the 2013 Infiniti M56 and 2013 Infiniti M37. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK CONNECTOR 
    1. Turn the ignition switch OFF.
    2. Disconnect the battery cable from the negative terminal.
    3. Check the terminals and connectors of the side radar RH for damage, bend and loose connection (unit side and connector side).

      Is the inspection result normal? 

      YES: GO TO 2.

      NO: Repair the terminal and connector.

  2. CHECK RIGHT/LEFT SWITCHING SIGNAL CIRCUIT 

    Check the right/left switching signal circuit of the side radar RH. Refer to "DIAGNOSIS PROCEDURE ".

    Is the inspection result normal? 

    YES: GO TO 3.

    NO: Repair the root cause.

  3. CHECK HARNESS FOR OPEN CIRCUIT 
    1. Disconnect the connector of side radar RH.
    2. Check the resistance between the side radar RH harness connector terminals.
      Side radar RH harness connector Resistance (Ω)
      Connector No. Terminal No.
      B252 4 3 Approx. 54 - 66

      Is the measurement value within the specification? 

      YES: GO TO 4.

      NO: Repair the side radar RH branch line.

  4. CHECK POWER SUPPLY AND GROUND CIRCUIT 

    Check the power supply and the ground circuit of the side radar RH. Refer to "SIDE RADAR RH: DIAGNOSIS PROCEDURE ".

    Is the inspection result normal? 

    YES (Present error): Replace the side radar RH. Refer to "REMOVAL AND INSTALLATION ".

    YES (Past error): Error was detected in the side radar RH branch line.

    NO: Repair the power supply and the ground circuit.

scientia non olet · About LEMON Manuals