Power Supply Position Change Table By Push-Button Ignition Switch Operation
WARNING: This page is about a different car, the 2013 Nissan Murano. However, it is still accessible from the selected car via links, so may be relevant.
The power supply position changing operation can be performed with the following operations.
NOTE:
- When an Intelligent Key is within the detection area of inside key antenna and when it is inserted to the key slot, it is equivalent to the operations below.
- When starting the engine, the BCM monitors under the engine start conditions,
- Brake pedal operating condition
- Selector lever position
- Vehicle speed
- This models do not have the steering lock system. However, power supply position changes to the LOCK position without steering lock operation when the following conditions are fulfilled.
- Ignition switch: OFF
- Shift lever position: P
- Any of the following condition is met
- Opening door
- Closing door
- Door is locked by request switch operation
- Door is locked by Intelligent Key operation
POWER SUPPLY POSITION DESCRIPTION (VEHICLE SPEED: LESS THAN 4 KM/H (2.5 MPH))
| Power supply position | Engine start/stop condition | Push-button ignition switch operation frequency | ||
|---|---|---|---|---|
| With steering lock unit | Without steering lock unit | Selector lever | Brake pedal operation condition | |
| LOCK → ACC | OFF → ACC | - | Not depressed | 1 |
| LOCK → ACC → ON | OFF → ACC → ON | - | Not depressed | 2 |
| LOCK → ACC → ON → OFF | OFF → ACC → ON → OFF | - | Not depressed | 3 |
| LOCK → START ACC → START ON → START |
OFF → START ACC → START ON → START |
P or N position | Depressed | 1 |
| Engine is running → OFF | Engine is running → OFF | - | - | 1 |
POWER SUPPLY POSITION DESCRIPTION (FOR VEHICLE SPEED: 4 KM/H (2.5 MPH) OR MORE)
| Power supply position | Engine start/stop condition | Push-button ignition switch operation frequency | |
|---|---|---|---|
| Selector lever | Brake pedal operation condition | ||
| Engine is running → ACC | - | - | Emergency stop operation |
| Engine stall return operation while driving | N position | Not depressed | 1 |
Emergency stop operation
- Press and hold the push-button ignition switch for 2 seconds or more.
- Press the push-button ignition switch 3 times or more within 1.5 seconds.