DTC Confirmation Procedure

If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.

1. Turn ignition switch OFF and wait at least 10 seconds.
2. Turn ignition switch ON.
3. Turn ignition switch OFF and wait at least 10 seconds.

GO TO STEP 2  .

1. Turn ignition switch ON.
2. Select "DATA MONITOR" mode with CONSULT.
3. Check that "COOLAN TEMP/S" is above 10°C (50°F).

Is the temperature above 10°C (50°F)?

YES 

INSPECTION END

NO 

GO TO STEP 3  .

1. Start engine and run it for 65 minutes at idle speed.

   If "COOLAN TEMP/S" increases to more than 10°C (50°F) within 65 minutes, stop engine because the test result will be OK. 

   CAUTION:

   Be careful not to overheat engine.

2. Check 1st trip DTC.

Is 1st trip DTC detected?

YES 

DIAGNOSIS PROCEDURE 

NO 

INSPECTION END