Diagnostic Test
- CHECK GROUND CONNECTION
- Turn ignition switch OFF.
- Check ground connection M95. Refer to Ground Inspection in CIRCUIT INSPECTION .
Is the inspection result normal?
YES
GO TO STEP 2 .
NO
Repair or replace ground connection.
- CHECK THROTTLE POSITION SENSOR POWER SUPPLY CIRCUIT-I
- Disconnect electric throttle control actuator harness connector.
- Turn ignition switch ON.
- Check the voltage between electric throttle control actuator harness connector and ground.
DTC Electric throttle control actuator Ground Voltage (V) Bank Connector Terminal P1239 2 F27 1 Ground Approx. 5 P2135 1 F6 6
Is the inspection result normal?
YES
GO TO STEP 3 .
NO
Repair open circuit, short to ground or short to power in harness or connectors.
- CHECK THROTTLE POSITION SENSOR GROUND CIRCUIT FOR OPEN AND SHORT
- Turn ignition switch OFF.
- Disconnect ECM harness connector.
- Check the continuity between electric throttle control actuator harness connector and ECM harness connector.
DTC Electric throttle control actuator ECM Continuity Bank Connector Terminal Connector Terminal P1239 2 F27 4 F101 48 Existed P2135 1 F6 3 40 - Also check harness for short to ground and short to power.
Is the inspection result normal?
YES
GO TO STEP 4 .
NO
Repair open circuit, short to ground or short to power in harness or connectors.
- CHECK THROTTLE POSITION SENSOR INPUT SIGNAL CIRCUIT FOR OPEN AND SHORT
- Check the continuity between electric throttle control actuator harness connector and ECM harness connector.
DTC Electric throttle control actuator ECM Continuity Bank Connector Terminal Connector Terminal P1239 2 F27 2 F101 31 Existed 3 35 P2135 1 F6 4 30 5 34 - Also check harness for short to ground and short to power.
Is the inspection result normal?
YES
GO TO STEP 5 .
NO
Repair open circuit, short to ground or short to power in harness or connectors.
- Check the continuity between electric throttle control actuator harness connector and ECM harness connector.
- CHECK THROTTLE POSITION SENSOR
Refer to COMPONENT INSPECTION .
Is the inspection result normal?
YES
GO TO STEP 7 .
NO
GO TO STEP 6 .
- REPLACE ELECTRIC THROTTLE CONTROL ACTUATOR
- Replace malfunctioning electric throttle control actuator. Refer to EXPLODED VIEW .
- SPECIAL REPAIR REQUIREMENT .
INSPECTION END
- CHECK INTERMITTENT INCIDENT
Refer to INTERMITTENT INCIDENT .
INSPECTION END