Diagnosis Procedure

1. Turn ignition switch OFF.
2. Disconnect push-button ignition switch connector.
3. Check voltage between push-button ignition switch harness connector and ground.

   (+)		(-)	Voltage (V) (Approx.)
   Push-button ignition switch
   Connector	Terminal
   M50	4	Ground	Battery voltage

Is the inspection result normal?

YES 

GO TO STEP 3  .

NO 

GO TO STEP 2  .

1. Disconnect BCM connector and IPDM E/R connector.
2. Check continuity between push-button ignition switch harness connector and BCM harness connector.

   Push-button ignition switch		BCM		Continuity
   Connector	Terminal	Connector	Terminal
   M50	4	M121	60	Existed

3. Check continuity between push-button ignition switch harness connector and ground.

   Push-button ignition switch		Ground	Continuity
   Connector	Terminal
   M50	4		Not existed

Is the inspection result normal?

YES 

Replace BCM. Refer to REMOVAL AND INSTALLATION .

NO 

Repair or replace harness.

Check continuity between push-button ignition switch harness connector and ground.

Is the inspection result normal?

YES 

GO TO STEP 4  .

NO 

Repair or replace harness.

Refer to COMPONENT INSPECTION .

Is the inspection result normal?

YES 

GO TO STEP 5  .

NO 

Replace push-button ignition switch. Refer to REMOVAL AND INSTALLATION .

Refer to INTERMITTENT INCIDENT .

INSPECTION END