DTC Detection Logic

NOTE:

If DTC B2605 is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to DTC LOGIC .
If DTC B2605 is displayed with DTC U1010, first perform the trouble diagnosis for DTC U1010. Refer to DTC LOGIC .

DTC No.	Trouble diagnosis name	DTC detecting condition	Possible cause
B2605	PNP/CLUTCH SW	BCM detects the following status for 500 ms or more when the ignition switch is in the ON position N position input signal exists. Shift position signal from IPDM E/R does not exist. N position input signal does not exist. Shift position signal from IPDM E/R exists.	Harness or connectors (TCM circuit is open or shorted) TCM IPDM E/R