Data Monitor
NOTE:
The following table includes information (items) inapplicable to this vehicle. For information (items) applicable to this vehicle, refer to CONSULT display items.
| Monitor item (Unit) | Remarks |
|---|---|
| WARNING LAMP (On/Off) | Hybrid EPS (Electrical Power Steering) warning lamp control status is displayed. |
| STEERING ANGLE SENSOR STATUS (Abnormal/Normal) | Steering angle sensor malfunction status is displayed from steering angle sensor via CAN communication. |
| HEV/ENGINE STATUS (STOP/RUN) | Hybrid system start status is displayed from HPCM via CAN communication. |
| FLOW CONNECTION VALVE (OPEN/CLOSE) | Displays the open/close status for flow connection valve. |
| BATTERY VOLT (V) | Displays the power supply voltage for power steering control module. |
| STEERING TORQUE (Nm) | Steering wheel turning force is displayed from torque sensor via CAN communication. |
| STEERING ANGLE SIGNAL (deg) | Steering angle value is displayed from steering angle sensor via CAN communication. |
| STEERING ANGLE SPEED (deg/s) | Displays the steering angle speed calculated by the power steering control module. |
| MOTOR CURRENT (A) | Displays the current value consumed by power steering motor. |
| MOTOR TORQUE COMMAND (Nm) | Displays a target torque value of the power steering motor. |
| ASSIST LEVEL (%) | Assist limit value is displayed for power steering motor.* 1 |
| VEHICLE SPEED (km/h or mph) | Vehicle speed is displayed from combination meter via CAN communication.* 2 |
| MOTOR REVOLUTION SPEED (RPM) | Displays the revolutions for power steering motor. |
| CONTROL MODULE ESTM TEMP (°C or °F) | Displays a power steering motor drive circuit temperature estimated by the control module. |
| HEAT PROTCT STATUS (NORMAL/PRTECT) | Displays a heat protection status by power steering oil pump assembly |
* 1: Normally displays 100%. In case of an excessive stationary steering, the assist curvature gradually falls However, it returns to 100% when left standing.
* 2: It is not a malfunction, though it might not be corresponding just after ignition switch in turned ON.