April 5, 2026: LEMON Manuals is launched! Read the announcement.

Work Procedure

NOTE:

In fail-safe mode, can not perform work support. (Except that DTC P181F or P182B is detected.)

PREPARATION BEFORE WORK

With CONSULT

Continue the following condition at vehicle.

Engine	: Running
Parking brake	: Apply
Brake pedal	: Release
Electrical system like air conditioner	: OFF

CAUTION:

Never drive the vehicle.

Check "4WD MODE", "T/M RANGE", "COMPR VHCL SPEED", "MOTOR POWER SUP" of CONSULT "DATA MONITOR" for "ALL MODE AWD/4WD".

Continue the following condition.

4WD MODE	: 4L
T/M RANGE	: N
COMPR VHCL SPEED	: 0 km/h (Never drive the vehicle)
MOTOR POWER SUP	: More than 11 V

GO TO STEP 2 .

PERFORM LOCK POSITION SENOR LEARNING

With CONSULT
1. Select "LOCK SLEEVE SENSOR LEARNING" of CONSULT "WORK SUPPORT" for "ALL MODE AWD/4WD".
2. Select "Start".
3. Wait until the motor operation stop.
Is "Error" detected?

YES (within 5 times)

GO TO STEP 1 .

YES (over 5 times)

Transfer assembly is mechanical malfunction. Replace transfer assembly. Refer to REMOVAL AND INSTALLATION .

NO

GO TO STEP 3 .

PERFORM SELF-DIAGNOSIS

With CONSULT
1. Erase self-diagnosis result for "ALL MODE AWD/4WD".
2. Turn the ignition switch ON to OFF.
  CAUTION:
  Wait for 10 seconds after turning ignition switch OFF.
3. Start the engine.
  CAUTION:
  Never drive the vehicle.
4. Perform self-diagnosis for "ALL MODE AWD/4WD".
Is "DTC P182B" detected?

YES

GO TO STEP 1 .

NO

WORK END