Work Procedure

WARNING: This page is about a different car, the 2019 Infiniti Q50. However, it is still accessible from the selected car via links, so may be relevant.

SAVING VEHICLE SPECIFICATION (BCM)
CONSULT Configuration
1. Select "Re/programming, Configuration".
2. Select the operation according to the CONSULT screen.
3. Perform "Before ECU Replacement" of "Vehicle Configuration" to write vehicle specification.
NOTE: If "Before ECU Replacement" of "Vehicle Configuration" cannot be used, use the "Manual Configuration" after replacing BCM. Refer to Description .

GO TO 2.
SAVING VEHICLE SPECIFICATION (TPMS) (IF EQUIPPED)
Perform saving vehicle specification (TPMS). Work Procedure (Before Replacement)

GO TO 3.
REPLACE BCM
Replace BCM. Refer to Removal and Installation .

GO TO 4.
WRITING VEHICLE SPECIFICATION (BCM)
CONSULT Configuration

Select "Re/programming, Configuration". Refer to Description .

GO TO 5.
INITIALIZATION AND REREGISTRATION OF ALL KEYS
Perform initialization and reregistration of all keys: Refer to CONSULT Immobilizer mode and follow the on-screen instructions.

GO TO 6.
WRITING VEHICLE SPECIFICATION (TPMS) (IF EQUIPPED)
Perform writing vehicle specification (TPMS). Work Procedure (After Replacement)

WORK END