Work Procedure
- WRITING MODE SELECTION
CONSULT Configuration
Select "Re/programming, Configuration" of "MULTI AV".
When writing saved data
GO TO STEP 2 .
When writing manually
GO TO STEP 3 .
- WRITING VEHICLE SPECIFICATION
CONSULT Configuration
Select "Configuration" or "After Replace ECU", and write the vehicle specification saved in CONSULT to display control unit.
CAUTION:Do not perform any operation such as the navigation operation during configuration writing.
GO TO STEP 4 .
- WRITE VEHICLE SPECIFICATION
CONSULT Configuration
Select "Manual Configuration", and write the setting value as shown in the following table to display control unit according to the vehicle specification.
CAUTION:Grasp vehicle specifications precisely. The control of ECU may not function normally if the specifications are misread.
NOTE:- The items shown in this list depend on vehicle specifications.
- The config list may not be displayed depending on vehicle specifications. This is not a malfunction.
- If selection items are not displayed on the CONSULT screen, touch "NEXT".
MANUAL SETTING ITEM Detail Items Setting value NAVIGATION WITH Models with navigation WITHOUT Models without navigation HYBRID OFF Except hybrid models FR TYPE Hybrid models (2WD) FR TYPE 4WD Hybrid models (4WD) CAMERA SYSTEM REAR CAMERA With rear view monitor system NONE/AVM ph3 With around view monitor system SONAR TYPE NONE Models without sonar FRONT&REAR Models with sonar AUDIO AMP TYPE 160W AMP Models without BOSE system 2ch AMP Models with BOSE system LDP (LANE DEPARTURE PREVENTION) On Models with LDP Off Models without LDP PREDICTIVE COURSE LINE WITHOUT/WITH AVM With around view monitor system WITH (RVM WITHOUT DAST) With rear view monitor system without direct adaptive steering WITH (RVM WITH DAST) With rear view monitor system and direct adaptive steering DESTINATION US Except for Canada CAN For Canada GO TO STEP 5 .
- PERFORM SELF-DIAGNOSIS
CONSULT Self Diagnostic Result
Perform self-diagnosis of CONSULT, and check whether or not DTC U1223 is detected.
Is DTC U1223 detected?
YES
GO TO STEP 3 .
NO
GO TO STEP 5 .
- OPERATION CHECK
Check that the operation of the display control unit and camera images (fixed guide lines and predictive course lines) are normal.
WORK END