Values On The Diagnosis Tool
NOTE:
The following table includes information (items) inapplicable to this vehicle. For information (items) applicable to this vehicle, refer to CONSULT display items.
| Monitor item | Data monitor | ||
|---|---|---|---|
| Condition | Display value | ||
| BATTERY VOLT | Engine running | Battery voltage (V) | |
| AUTO STOP START FLAG | Engine running | No steering wheel operation | OK |
| Steering wheel operation | NG | ||
| AUTO STOP START STATUS | During stop/start system operation | On | |
| Restart (engine cranking) | CRANK | ||
| Engine running | Off | ||
| Idle Stop Act | Stop/start system is active | On | |
| Stop/start system is not active | Off | ||
| STEERING MODE | Steering mode: Standard | NORML | |
| Steering mode: Sport | SPORT | ||
| STEERING ANGLE | The steering wheel is not steered. | Approx. 0.0 deg | |
| The steering wheel is steered. | Displays steering angle speed (deg) | ||
| STR ANG SPD | The steering wheel is not steered. | Approx. 0.0 deg/s | |
| The steering wheel is steered. | Displays steering angle speed (deg/s) | ||
| MOTOR CURRENT | Engine running | Steering wheel: Not steering (There is no steering force) | MAX approx. 10 A* 1 |
| Steering wheel: Right or left turn | Displays consumption current of power steering control module (A) | ||
| MTR REV SPD COMM | Engine running | Steering wheel: Not steering (There is no steering force) | Shows an almost constant value (RPM) |
| Steering wheel: Right or left turn | The value changes as a steering speed (RPM) | ||
| MTR REV SPD | Engine running | Steering wheel: Not steering (There is no steering force) | Shows an almost constant value (RPM)* 2 |
| Steering wheel: Right or left turn | The value changes as a steering speed (RPM)* 2 | ||
| C/U TEMP | Engine running | Displays temperature of inside of power steering control module (°C or °F) | |
| C/U TEMP A | Engine running | Displays temperature of inside of power steering control module (°C or °F) | |
| MTR ASSIST | Engine running | 100%* 3 | |
| ESTM VHCL SPD | Vehicle stopped | 0.00 km/h or mph | |
| While driving | Approximately equal to the indication on speedometer*4 (inside of +-10%) |
||
| WARNING LAMP | Power steering warning lamp: ON | On | |
| Power steering warning lamp: OFF | Off | ||
| ENGINE STATUS | Engine not running | STOP | |
| Engine running | RUN | ||
| Engine cranking | CRANK | ||
| VHCL SPD JUDGE | Vehicle speed signal can be received via CAN communication | OK | |
| Vehicle speed signal cannot be received via CAN communication | NG | ||
* 1: The value changes according to load of power steering motor.
* 2: This is in close agreement with a motor speed command value. Although a quick steering operation may cause disagreement, this is not a malfunction.
* 3: Usually, 100% is displayed. An excessive steering operation gradually lowers the percentage. When left standing, the percentage returns to 100%.
* 4: This may not agree with the speedometer indication immediately after the ignition switch is turned ON. This is not a malfunction.