DTC Detection Logic

NOTE:

If DTC B2605 is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to DTC LOGIC .
If DTC B2605 is displayed with DTC U1010, first perform the trouble diagnosis for DTC U1010. Refer to DTC LOGIC .

DTC No.	Trouble diagnosis name	DTC detecting condition	Possible cause
B2605	PNP SWITCH	BCM detects the following status for 500 ms or more when the ignition switch is in ON position N position input signal exists. Shift position signal from IPDM E/R does not exist. N position input signal does not exist. Shift position signal from IPDM E/R exists.	Harness or connectors (Transmission range switch circuit is open or shorted.) Transmission range switch IPDM E/R