April 5, 2026: LEMON Manuals is launched! Read the announcement.

Diagnostic Test

CHECK THROTTLE POSITION SENSOR

Turn ignition switch OFF.
Reconnect all harness connectors disconnected.
Perform DESCRIPTION .
Turn ignition switch ON.
Set selector lever to D position.

Check the voltage between ECM harness connector terminals under the following conditions:

ECM			Condition		Voltage (V)
Connector	+	-
Connector	Terminal	Terminal
F101	30 [TP sensor 1 (bank 1)]	40	Accelerator pedal	Fully released	More than 0.36
	30 [TP sensor 1 (bank 1)]	40		Fully depressed	Less than 4.75
	31 [TP sensor 1 (bank 2)]	48		Fully released	More than 0.36
	31 [TP sensor 1 (bank 2)]	48		Fully depressed	Less than 4.75
	34 [TP sensor 2 (bank 1)]	40		Fully released	Less than 4.75
	34 [TP sensor 2 (bank 1)]	40		Fully depressed	More than 0.36
	35 [TP sensor 2 (bank 2)]	48		Fully released	Less than 4.75
	35 [TP sensor 2 (bank 2)]	48		Fully depressed	More than 0.36

Is the inspection result normal?

YES

INSPECTION END

NO

GO TO STEP 2 .

REPLACE ELECTRIC THROTTLE CONTROL ACTUATOR
1. Replace malfunctioning electric throttle control actuator. Refer to REMOVAL AND INSTALLATION .
2. Go to SPECIAL REPAIR REQUIREMENT .
INSPECTION END