DTC Confirmation Procedure

If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.

1. Turn ignition switch OFF and wait at least 10 seconds.
2. Turn ignition switch ON.
3. Turn ignition switch OFF and wait at least 10 seconds.

GO TO STEP 2  .

1. Start engine (VDC switch OFF).
2. Drive the vehicle at more than 40 km/h (25 MPH).
   CAUTION:

   Always drive vehicle at a safe speed.

   NOTE:

   This procedure may be conducted with the drive wheels lifted in the shop or by driving the vehicle. If a road test is expected to be easier, it is unnecessary to lift the vehicle. 

3. Check DTC.

Is DTC detected?

YES 

Go to DIAGNOSIS PROCEDURE .

NO 

INSPECTION END