LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Infiniti >> 2016 >> QX60 Base, FWD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Drivers Assistance Systems - ADAS >> Driver Assistance System (Introduction, Wiring Diagrams And Basic Inspection) (BCI) (Except Hybrid) >> Basic Inspection >> Diagnosis And Repair Work Flow >> Work Flow >> Detailed Flow
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Detailed Flow

  1. INTERVIEW FOR MALFUNCTION

    It is also important to clarify the customer concerns before starting the inspection. Interview the customer about the concerns carefully and understand the symptoms fully.

    NOTE:

    The customers are not professionals. Never assume that "maybe the customer means•••" or "maybe the customer mentioned this symptom".

    GO TO STEP 2. 

  2. SELF - DIAGNOSIS WITH CONSULT

    1. Perform "All DTC Reading" with CONSULT.
    2. Check if the DTC is detected on the self-diagnosis results of "SIDE RADAR LEFT/RIGHT", "SONAR", and/or "ICC/ADAS".

    Is any DTC detected?

    YES 

    GO TO STEP 5. 

    NO 

    GO TO STEP 3. 

  3. PRE-INSPECTION FOR DIAGNOSIS

    Perform pre-inspection for diagnosis. Refer to INSPECTION PROCEDURE .

    GO TO STEP 4  .

  4. ACTION TEST

    Perform Backup Collision Intervention system action test to check the operation status. Refer to WORK PROCEDURE .

    Check if any other malfunctions occur.

    GO TO STEP 6. 

  5. TROUBLE DIAGNOSIS BY DTC

    1. Check the DTC in the self-diagnosis results.
    2. Perform trouble diagnosis for the detected DTC. Refer to DTC INDEX  or DTC INDEX  (SIDE RADAR LEFT/RIGHT), DTC INDEX (SONAR) and/or DTC INDEX  (ICC/ADAS).
    NOTE:

    If "DTC: U1000" is detected, first diagnose the CAN communication system or ITS communication system.

    GO TO STEP 7. 

  6. SYMPTOM DIAGNOSIS

    Perform the applicable diagnosis according to the diagnosis chart by symptom. Refer to SYMPTOM TABLE .

    GO TO STEP 7. 

  7. MALFUNCTIONING PART REPAIR

    Repair or replace the identified malfunctioning parts.

    GO TO STEP 8. 

  8. REPAIR CHECK (SELF-DIAGNOSIS WITH CONSULT)

    1. Erases self-diagnosis results.
    2. Perform "All DTC Reading" again after repairing or replacing the specific items.
    3. Check if any DTC is detected in self-diagnosis results of "SIDE RADAR LEFT/RIGHT", "SONAR" and "ICC/ADAS".

    Is any DTC detected?

    YES 

    GO TO STEP   5 . 

    NO 

    GO TO STEP 9. 

  9. REPAIR CHECK (ACTION TEST)

    Perform the Backup Collision Intervention system action test. Check that the malfunction symptom is solved or no other symptoms occur.

    Is there a malfunction symptom?

    YES 

    GO TO STEP   4 . 

    NO 

    Inspection End.

scientia non olet · About LEMON Manuals