LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Infiniti >> 2016 >> QX60 Base, FWD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Drivers Assistance Systems - ADAS >> Intelligent Cruise Control System (Introduction, Wiring Diagrams And Basic Inspection) (ICC) (Except Hybrid) >> System Description >> System >> Vehicle-To-Vehicle Distance Control Mode Function >> System Description >> Operation Description >> Set Condition
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Set Condition

Under a standby state, pushing down the SET/COAST switch will start system control.

If the system is canceled by conditions 1 - 6 below, the system will resume control at the last set cruising speed by pushing up the RESUME/ACCELERATE switch.

NOTE:
  • When the SET/COAST switch is pushed under the following conditions, the system cannot be set and the set vehicle speed indicator will blink for approximately 2 seconds.
    • When traveling below 32 km/h (20 MPH) and the vehicle ahead is not detected.
    • When the selector lever is not in the "D" position or manual mode.
    • When the parking brakes are applied.
    • When the brakes are operated by the driver.
  • When the SET/COAST switch is pushed under the following conditions, the system cannot be set and a warning chime will sound and displays that causes in combination meter (information display).
    • When the drive mode select switch is in SNOW position. (To use the ICC system, turn OFF the snow mode, push the ICC MAIN switch to turn OFF the ICC system and reset the ICC system by pushing the ICC MAIN switch again.)
    • When the VDC is OFF. (To use the ICC system, turn ON the VDC system, push the MAIN switch to turn OFF the ICC system and reset the ICC system by pushing the MAIN switch again.)
    • When ABS or VDC (including the TCS) operates.
    • When the wheel is slipping. (To use the ICC system, make sure the wheels are no longer spinning, push the MAIN switch to turn OFF the ICC system and reset the ICC system by pushing the MAIN switch again.)