Detailed Flow
- CHECK SYMPTOM
Check the malfunction symptoms by performing the following items:
- Interview the customer to obtain the malfunction information (conditions and environment when the malfunction occurred).
- Check the symptom.
GO TO STEP 2
- SELF-DIAGNOSIS (CONSULT)
- Connect CONSULT and perform "SELF-DIAGNOSIS" for "MULTI AV".NOTE:
Skip to step 4 of the diagnosis procedure if "MULTI AV" is not displayed.
- Check if any DTC No. is displayed in the self-diagnosis results.
Is any DTC No. displayed?
YES
GO TO STEP 3
NO
GO TO STEP 4
- Connect CONSULT and perform "SELF-DIAGNOSIS" for "MULTI AV".
- CHECK SELF-DIAGNOSIS RESULTS (CONSULT)
- Check the DTC No. indicated in the self-diagnosis results.
- Perform the relevant diagnosis referring to the DTC No. list. Refer to DTC INDEX .
NOTE:Start with the diagnosis for the CAN communication system if "CAN COMM CIRCUIT [U1000] or CONTROL UNIT (CAN) [U1010]" is displayed.
GO TO STEP 5
- PERFORM DIAGNOSIS BY SYMPTOM
Perform the relevant diagnosis referring to the diagnosis chart by symptom. Refer to SYMPTOM TABLE .
GO TO STEP 5
- REPAIR OR REPLACE MALFUNCTIONING PARTS
Repair or replace the identified malfunctioning parts.
NOTE:Erase the stored self-diagnosis results after repairing or replacing the relevant components if any DTC No. has been indicated in the self-diagnosis results.
GO TO STEP 6
- CHECK AFTER REPAIR
- Perform self-diagnosis for "MULTI AV" with CONSULT after repairing or replacing the malfunctioning parts.
- Check if any DTC No. is displayed in the self-diagnosis results.
Is any DTC No. displayed?
YES
GO TO STEP 3
NO
GO TO STEP 7
- FINAL CHECK
Perform the operation check to confirm that the malfunction symptom is solved or that any other symptoms are present.
Are any symptoms present?
YES
GO TO STEP 4
NO
Inspection End.