Work Procedure
- SAVING VEHICLE SPECIFICATION
CONSULT Configuration
Perform "Before Replace ECU", and save the current vehicle specification in CONSULT.
Is the vehicle specification saved normally?
YES
GO TO STEP 2 .
NO
GO TO STEP 4 .
- REPLACE AV CONTROL UNIT
Replace AV control unit. Refer to REMOVAL AND INSTALLATION .
GO TO STEP 3 .
- WRITING VEHICLE SPECIFICATION
Select "Configuration" or "After Replace ECU", and write the vehicle specification saved in CONSULT to AV control unit.
GO TO STEP 6 .
- REPLACE AV CONTROL UNIT
Replace AV control unit. Refer to REMOVAL AND INSTALLATION .
GO TO STEP 5 .
- WRITE VEHICLE SPECIFICATION
Select "Manual Configuration", and write the setting value as shown in the following table to AV control unit according to the vehicle specification.
CAUTION:Grasp vehicle specifications precisely. The control of ECU may not function normally if the specifications are misread.
NOTE:- The items shown in this list depend on vehicle specifications.
- The config list may not be displayed depending on vehicle specifications. This is not a malfunction.
- If selection items are not displayed on the CONSULT screen, touch "NEXT".
MANUAL SETTING ITEM Detail Items Setting value STEERING LHD LHD models RHD RHD models CAMERA SYSTEM NONE/AVM Without camera system or with around view monitor system REAR With rear view monitor system REAR+SIDE With rear view monitor system and front-side view monitor function SOUND SYSTEM BASE Without BOSE system BOSE With BOSE system BOSE SURROUND With BOSE surround system ROCKFORD FOSGATE - ROCKFORD SUB WOOFER - AUXILIARY INPUT JACKS WITH With auxiliary input jacks WITHOUT Without auxiliary input jacks MICROPHONE DIRECTIONAL MIC With directional microphone* NON-DIRECTIONAL MIC With non-directional microphone* NOTE:- AVM: Around view monitor
- * : In the following table, find an illustration that the
part matches the vehicle and select microphone type.
Directional microphone Non-directional microphone GO TO STEP 6 .
- PERFORM SELF-DIAGNOSIS
Perform self-diagnosis of CONSULT, and check whether or not DTC U122A is detected.
Is DTC U122A detected?
YES
GO TO STEP 5 .
NO
GO TO STEP 7 .
- OPERATION CHECK
Check that the operation of the AV control unit and camera images (fixed guide lines and predictive course lines) are normal.
WORK END