Test Item
ABS SOLENOID VALVE
- Select "Up", "Keep" and "Down" of "ACTIVE TEST" in "ABS" with CONSULT. Then use screen monitor to check that solenoid valve operates as shown in the table below.
Test item Display item Display (Note) Up Keep Down FR RH SOL FR RH IN SOL Off On On FR RH OUT SOL Off Off On* CV2 Off Off Off SV2 Off Off Off FR LH SOL FR LH IN SOL Off On On FR LH OUT SOL Off Off On* CV1 Off Off Off SV1 Off Off Off RR RH SOL RR RH IN SOL Off On On RR RH OUT SOL Off Off On* CV1 Off Off Off SV1 Off Off Off RR LH SOL RR LH IN SOL Off On On RR LH OUT SOL Off Off On* CV2 Off Off Off SV2 Off Off Off *: On for 1 to 2 seconds after the select, and then Off.
NOTE:A brief moment of On/Off condition occurs every 20 seconds after ignition switch turned ON. This is not malfunction because it is an operation for checking.
ABS SOLENOID VALVE (ACT)
- Select "Up", "ACT UP" and "ACT KEEP" of "ACTIVE TEST" in "ABS" with CONSULT. Then use screen monitor to check that solenoid valve operates as shown in the table below.
Test item Display item Display (Note) Up ACT UP ACT KEEP FR RH ABS SOLENOID (ACT) FR RH IN SOL Off Off Off FR RH OUT SOL Off Off Off CV2 Off On On SV2 Off On* Off FR LH ABS SOLENOID (ACT) FR LH IN SOL Off Off Off FR LH OUT SOL Off Off Off CV1 Off On On SV1 Off On* Off RR RH ABS SOLENOID (ACT) RR RH IN SOL Off Off Off RR RH OUT SOL Off Off Off CV1 Off On On SV1 Off On* Off RR LH ABS SOLENOID (ACT) RR LH IN SOL Off Off Off RR LH OUT SOL Off Off Off CV2 Off On On SV2 Off On* Off *: On for 1 to 2 seconds after the select, and then Off.
NOTE:A brief moment of On/Off condition occurs every 20 seconds after ignition switch turned ON. This is not malfunction because it is an operation for checking.
ABS MOTOR
- Select "On" and "Off" of "ACTIVE TEST" in "ABS" with CONSULT. Make sure motor relay and actuator relay operates as shown in table below.
Test item Display item Display On Off ABS MOTOR MOTOR RELAY On Off ACTUATOR RLY (Note) On On NOTE:A brief moment of On/Off condition occurs every 20 seconds after ignition switch turned ON. This is not malfunction because it is an operation for checking.