VVEL Control Shaft Position Sensor Adjustment: Description
WARNING: This page is about a different car, the 2016 Infiniti QX50. However, it is still accessible from the selected car via links, so may be relevant.
VVEL control shaft position sensor adjustment is an operation to adjust the initial position angle that is the basis for the VVEL control shaft position sensor.
It must be performed each time VVEL actuator sub assembly is replaced. Refer to SPECIAL REPAIR REQUIREMENT .
CAUTION:
- It must be performed only on the replaced bank side.
- It must not be performed except when VVEL actuator sub assembly is replaced. If by any chance the adjustment is performed, replace VVEL actuator sub assembly.