Ignition Battery Saver System
WARNING: This page is about a different car, the 2016 Infiniti Q50. However, it is still accessible from the selected car via links, so may be relevant.
When all the following conditions are met for 30 minutes, the battery saver system will cut off the power supply (ignition switch position ACC/ON → OFF) to prevent battery discharge.
- Ignition switch is in the ACC/ON position
- Turn signal lamp is not in operation
- Selector lever is in the P position
NOTE:
For one minute after thirty minutes have passed or three minutes after twenty-seven minutes are passed, the following display is indicated on information display in combination meter and sounds buzzer in combination meter.
| Combination meter | Time | |
|---|---|---|
| Information display | Buzzer | |
| Power turned off to save the battery | Pipi-Pipi (two seconds) |
For one minute after thirty minutes have passed |
| three minutes after twenty-seven minutes are passed | ||
RESET CONDITION OF IGNITION BATTERY SAVER SYSTEM
If any of the following conditions are met the battery saver system is released.
- Ignition switch is not in the ACC/ON position
- Turn signal lamp is in operation
- Selector lever is not in the P position
NOTE:
The ignition battery saver system can be temporarily disabled, without using CONSULT, to prevent it from functioning when performing trouble diagnosis. Refer to WORK PROCEDURE .