Data Monitor

WARNING: This page is about a different car, the 2019 Infiniti Q50. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: The following table includes information (items) inapplicable to this vehicle. For information (items) applicable to this vehicle, refer to CONSULT display items.

Monitor item (Unit)	Remarks
STOP LAMP SW (On/Off)	Stop lamp switch signal status via CAN communication line is displayed.
ENG SPEED SIG (Run/Stop)	Engine status is displayed.
ETS ACTUATOR (On/Off)	Operating condition of AWD actuator relay (integrated in AWD control unit) is displayed.
4WD WARN LAMP (On/Off)	Control status of AWD warning (on information display) is displayed.
4WD MODE SW (##)	Mode switch status is displayed. (This item is not equipped, but displayed.)
4WD MODE MON (AUTO)	Control status of AWD is displayed.
DIS-TIRE MONI (mm)	Improper size tire installed condition is displayed.
P BRAKE SW (On/Off)	Parking brake switch signal status via CAN communication line is displayed.
BATTERY VOLT (V)	Power supply voltage for AWD control unit.
THRTL POS SEN (%)	Throttle opening status is displayed.
ETS SOLENOID (A)	Monitored value of current at AWD solenoid.
FR RH SENSOR (km/h or mph)	Wheel speed calculated by front RH wheel sensor signal is displayed.
FR LH SENSOR (km/h or mph)	Wheel speed calculated by front LH wheel sensor signal is displayed.
RR RH SENSOR (km/h or mph)	Wheel speed calculated by rear RH wheel sensor signal is displayed.
RR LH SENSOR (km/h or mph)	Wheel speed calculated by rear LH wheel sensor signal is displayed.