VR30DDTT engine

1. Turn ignition switch OFF.
2. Disconnect push-button ignition switch connector and IPDM E/R connector.
3. Check voltage between push-button ignition switch harness connector and ground.

   (+)		(-)	Voltage
   Push-button ignition switch
   Connector	Terminal
   M38	8	Ground	9 - 16 V

Is the inspection result normal?

YES

GO TO 3.

NO

GO TO 2.

1. Disconnect BCM connector.
2. Check continuity between BCM harness connector and push-button ignition switch harness connector.

   BCM		Push-button ignition switch		Continuity
   Connector	Terminal	Connector	Terminal
   M13	1	M38	8	Existed

3. Check continuity between BCM harness connector and ground.

   BCM		Ground	Continuity
   Connector	Terminal
   M13	1		Not existed

Is the inspection result normal?

YES

Replace BCM. Refer to BCM : Removal & Installation .

NO

Repair or replace harness.

1. Disconnect BCM connector.
2. Connect IPDM E/R connector.
3. Check voltage between IPDM E/R harness connector and ground.

   (+)		(-)	Voltage
   IPDM E/R
   Connector	Terminal
   E121	38	Ground	6 - 16 V

Is the inspection result normal?

YES

GO TO 5.

NO

GO TO 4.

1. Check continuity between IPDM E/R harness connector and push-button ignition switch harness connector.

   IPDM E/R		Push-button ignition switch		Continuity
   Connector	Terminal	Connector	Terminal
   E121	38	M38	8	Existed

2. Check continuity between IPDM E/R harness connector and ground.

   IPDM E/R		Ground	Continuity
   Connector	Terminal
   E121	38		Not existed

Is the inspection result normal?

YES

Replace IPDM E/R. Refer to IPDM E/R : Removal & Installation .

NO

Repair or replace harness.

Check continuity between push-button ignition switch harness connector and ground.

Is the inspection result normal?

YES

GO TO 6.

NO

Repair or replace harness.

Refer to Component Inspection .

Is the inspection result normal?

YES

GO TO 7.

NO

Replace push-button ignition switch. Refer to PUSH-BUTTON IGNITION SWITCH : Removal & Installation .

Refer to Inspection .

INSPECTION END