Gasoline engine models

1. Turn ignition switch OFF.
2. Check that the following fuse in the fuse block (J/B) is not blown (open).

   Signal name	Fuse No.
   Battery power supply	6 (10 A)
   Ignition power supply	11 (5 A)

Is the fuse blown (open)?

YES

Replace the blown (open) fuse after repairing the cause of blowing.

NO

GO TO 2.

1. Disconnect combination meter connector.
2. Check voltage between combination meter harness connector and ground.

   (+)		(-)	Condition		Voltage
   Combination meter
   Connector	Terminal
   M58	45	Ground	Ignition switch	ON	Battery voltage
   	46			OFF, ACC or ON

Is the inspection result normal?

YES

GO TO 3.

NO

Repair or replace harness.

1. Connect combination meter connector.
2. Disconnect BCM connector.
3. Check voltage between BCM harness connector and ground.

   (+)		(-)	Voltage
   BCM
   Connector	Terminal
   M13	18	Ground	Battery voltage

Is the inspection result normal?

YES

GO TO 4.

NO

GO TO 5.

Replace BCM. Refer to BCM : Removal & Installation .

INSPECTION END

1. Disconnect combination meter connector.
2. Check continuity between combination meter harness connector and BCM harness connector.

   Combination meter		BCM		Continuity
   Connector	Terminal	Connector	Terminal
   M57	7	M13	18	Existed

3. Check continuity between combination meter harness connector and ground.

   Combination meter		Ground	Continuity
   Connector	Terminal
   M57	7		Not existed

Is the inspection result normal?

YES

Replace combination meter. Refer to COMBINATION METER : Removal & Installation .

NO

Repair or replace harness.