Diagnosis Procedure
- CHECK FUSE
- Turn Ignition Switch OFF.
- Check that the following fuse is not blown (open).VR30DDTT ENGINE
Power source Fuse No. Capacity Battery #7 15 A Ignitions switch ACC #1 10 A Ignition switch ON #14 5 A 2.0L TURBO GASOLINE ENGINEPower source Fuse No. Capacity Battery #84 15 A Ignitions switch ACC #93 10 A Ignition switch ON #77 10 A
Is the fuse blown (open)?
YES
Replace fuse after repairing the applicable circuit.
NO
GO TO STEP 2 .
- CHECK POWER SUPPLY CIRCUITS
Check voltage between Around View Monitor Control Unit harness connector and ground.
Signal name Terminals Ignition switch position Value (Approx.) (+) (-) Around View Monitor Control Unit Connector Terminal Battery power supply B50 2 Ground OFF Battery voltage ACC power supply 4 ACC Ignition signal 3 ON Is inspection result normal?
YES
GO TO STEP 3 .
NO
Check harness between Around View Monitor Control Unit and fuse.
- CHECK GROUND CIRCUIT
- Turn Ignition Switch OFF.
- Disconnect Around View Monitor Control Unit connector.
- Check continuity between Around View Monitor Control Unit harness connector and ground.
Terminals Continuity (+) (-) Around View Monitor Control Unit Connector Terminal B50 1 Ground Existed
Is inspection result normal?
YES
INSPECTION END
NO
Repair harness or connector.