Diagnosis Procedure

1. Turn Ignition Switch OFF.
2. Disconnect Push-Button Ignition Switch connector.
3. Check voltage between Push-Button Ignition Switch harness connector and ground.

   (+)		(-)	Voltage
   Push-Button Ignition Switch
   Connector	Terminal
   M38	3	Ground	Battery voltage

Is the inspection normal?

YES 

GO TO STEP 2  .

NO-1 

VR engine models: Check 10 A fuse [No. 6, located in fuse block (J/B)].

NO-2 

2.0L turbo gasoline engine models: Check 10 A fuse (No. 81).

NO-3 

Check harness for open or short between Push-Button Ignition Switch and fuse.

1. Connect Push-Button Ignition Switch connector.
2. Disconnect BCM connector.
3. Check voltage between BCM connector and ground.

   (+)		(-)	Voltage
   BCM
   Connector	Terminal
   M16	111	Ground	9 - 16 V

Is the inspection normal?

YES 

Replace BCM. Refer to REMOVAL AND INSTALLATION .

NO 

GO TO STEP 3  .

1. Disconnect Push-Button Ignition Switch connector.
2. Check continuity between BCM harness connector and Push-Button Ignition Switch harness connector.

   BCM		Push-Button Ignition Switch		Continuity
   Connector	Terminal	Connector	Terminal
   M16	111	M38	7	Existed

3. Check continuity between BCM harness connector and ground.

   BCM		Ground	Continuity
   Connector	Terminal
   M16	111		Not existed

Is the inspection normal?

YES 

Replace Push-Button Ignition Switch. Refer to REMOVAL AND INSTALLATION .

NO 

Repair or replace harness.