Diagnostic Test
WARNING: This page is about a different variant/trim than selected.
- PRECONDITIONING
Check that the engine is cold [coolant temperature: 50 °C (122 °F) or less].
Is the engine cold?
YES
GO TO STEP 2 .
NO
Park the vehicle at a cold place and cool down the engine. And then, GO TO STEP 2 .
- INITIALIZING A LEARNING VALUE
With CONSULT
- Start the engine and let it idle at least 10 seconds.
- On CONSULT screen, select "ENGINE" >> "Active Test" >> "WASTEGATE ACTUATOR".
- Operate the actuator from the fully closed position to the fully open position and check that actual value is within the range of (- 0.00052) - (+ 0.00052) m when the target value is set at 0 m.
END