Diagnostic Test

1. Turn the ignition switch OFF.
2. Disconnect force motor angle sensor harness connector.
3. Check resistance between force motor angle sensor connector pin terminals.

   Force motor angle sensor		Condition	Resistance (Approx.)
   Terminal
   3	7	0°C	34.8 kΩ
   		25°C	10.0 kΩ
   		40°C	5.2 kΩ

4. Check continuity between force motor angle sensor connector and ground.

   Force motor angle sensor	-	Continuity
   Terminal
   3	Ground	Not existed
   7

Is the inspection result normal?

YES 

INSPECTION END

NO 

Force motor temperature sensor is malfunction. Replace steering column assembly. Refer to REMOVAL AND INSTALLATION .