DTC Confirmation Procedure

If "DTC CONFIRMATION PROCEDURE" has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.

GO TO STEP 2  .

With CONSULT 

1. Start the engine.
   CAUTION:

   Never drive the vehicle.

2. Turn the steering wheel from full left stop to full right stop.
   NOTE:

   Perform the work at the place where curbstones or other substances does not interfere with tire.

3. Return the steering wheel to the straight-ahead position.
4. Perform self-diagnosis for "DAST 1".

Is DTC "C13E8 - 00" detected?

YES 

Proceed to diagnosis procedure. Refer to DIAGNOSIS PROCEDURE .

NO 

Protection function is active by operating steering wheel under a condition where the steering angle is physically restricted due to the influence of curbstones or other substances. This is not system malfunction. Since this may cause mechanical malfunction, check the suspension, axle and steering component.