Diagnostic Test
- PERFORM CONFIGURATION
Perform configuration for each control module. Refer to WORK PROCEDURE (EPS/DAST 3), WORK PROCEDURE (DAST 1), WORK PROCEDURE (DAST 2).
GO TO STEP 2 .
- PERFORM SELF-DIAGNOSIS
With CONSULT
- Turn the ignition switch ON.
- Erase self - diagnosis for "DAST 1".
- Turn the ignition switch OFF and wait for at least 10 seconds.
- Start engine.CAUTION:
Never drive the vehicle.
- Perform self - diagnosis for "DAST 1".
Is DTC "C13EE - 00" detected?
YES
Replace steering angle main control module. Refer to REMOVAL AND INSTALLATION .
NO
INSPECTION END