LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Infiniti >> 2017 >> Q60 Base, AWD >> Repair and Diagnosis >> Steering >> Steering Control Systems >> Steering Control System (Electric Power Steering) (DTC/Circuit Diagnosis) >> DTC / Circuit Diagnosis >> Power Supply And Ground Circuit >> Diagnosis Procedure >> Diagnostic Test
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Diagnostic Test

  1. CHECK THE GROUND CIRCUIT

    1. Turn the ignition switch OFF.
    2. Disconnect power steering control module harness connector.
    3. Check the continuity between power steering control module harness connector and ground.
      Power steering control module - Continuity
      Connector Terminal
      E177 1 Ground Existed

    Is the inspection result normal?

    YES 

    GO TO STEP 2  .

    NO 

    Repair open circuit in harness or connectors.

  2. CHECK THE BATTERY POWER SUPPLY CIRCUIT (1)

    Check the voltage between power steering control module harness connector and ground.

    Power steering control module - Voltage
    (Approx.)
    Connector Terminal
    E177 2 Ground 10.5 - 16 V

    Is the inspection result normal?

    YES 

    GO TO STEP 4  .

    NO 

    GO TO STEP 3  .

  3. CHECK THE BATTERY POWER SUPPLY CIRCUIT (2)

    1. Check the 100A fusible link (#J).
    2. Check the harness for open or short between power steering control module harness connector No. 2 terminal and the 100A fusible link (#J).

    Is the inspection result normal?

    YES 

    Perform the trouble diagnosis for battery power supply circuit. Refer to WIRING DIAGRAM - BATTERY POWER SUPPLY - .

    NO 

    Repair or replace error - detected parts.

  4. CHECK THE IGNITION POWER SUPPLY CIRCUIT (1)

    1. Check the voltage between power steering control module harness connector and ground.
      Power steering control module - Voltage
      (Approx.)
      Connector Terminal
      E176 4 Ground 0 V
    2. Turn the ignition switch ON.
    3. Check the voltage between power steering control module harness connector and ground.
      Power steering control module - Voltage
      (Approx.)
      Connector Terminal
      E176 4 Ground 10.5 - 16 V

    Is the inspection result normal?

    YES 

    GO TO STEP 6  .

    NO 

    GO TO STEP 5  .

  5. CHECK THE IGNITION POWER SUPPLY CIRCUIT (2)

    1. Turn the ignition switch OFF.
    2. Check the 10A fuse (#12).
    3. Check the continuity between power steering control module harness connector and fuse block (J/B) harness connector.
      Power steering control module Fuse block (J/B) Continuity
      Connector Terminal Connector Terminal
      E176 4 E65 11F Existed
    4. Check the continuity between power steering control module harness connector and ground.
      Power steering control module - Continuity
      Connector Terminal
      E176 4 Ground Not existed

    Is the inspection result normal?

    YES 

    Perform the trouble diagnosis for ignition power supply circuit. Refer to WIRING DIAGRAM - IGNITION POWER SUPPLY - .

    NO 

    Repair or replace error - detected parts.

  6. CHECK TERMINAL

    1. Check the power steering control module pin terminals for damage or loose connection with harness connector.
    2. Check the fuse block (J/B) pin terminals for damage or loose connection with harness connector.

    Is the inspection result normal?

    YES 

    Power steering control module is malfunctioning. Replace steering gear assembly. Refer to REMOVAL AND INSTALLATION .

    NO 

    Repair or replace error - detected parts.

scientia non olet · About LEMON Manuals