Data Monitor Mode

NOTE:

The following table includes information (items) inapplicable to this vehicle. For information (items) applicable to this vehicle, refer to CONSULT display items.

Monitor item	Unit	Remarks
BATTERY VOLT	V	Displays the power supply voltage for power steering control module.
STEERING TORQUE	Nm	Displays steering torque detected by torque sensor.
STEERING ANGLE SIGNAL	deg	Displays the steering angle based on steering angle signal transmitted by CAN communications.
STEERING ANGLE SPEED	deg/s	Displays the steering angle speed based on the steering angle signal transmitted by CAN communications.
MOTOR CURRENT	A	Display the current value consumed by EPS motor.
Target motor current	A	Displays the target motor current value.
C/U TEMP	°C	Displays the temperature of the power steering control module.
Assist level	%	Displays the current percentage of the allowable assist ratio EPS motor.
VEHICLE SPEED	km/h	Display the vehicle speed from vehicle speed signal via CAN communication.
WARNING LAMP	OFF/On	Displays the control status of power steering warning lamp.
STEERING ANGLE SENSOR STATUS	ABNORMAL/NORMAL	Displays the status of steering angle based on the steering angle status signal transmitted by CAN communications.
ENGINE STATUS	STOP/RUN/CRANK	Displays the engine status based on the engine status signal transmitted by CAN communications.
HEAT PROTCT STATUS	NORMAL/PRTECT	Displays the status of overheat protection.
MOTOR REVOLUTION SPEED	RPM	Displays the EPS motor speed.
CONTROL MODULE ESTM TEMP	°C	Displays the estimated temperature of power steering control module.
Steering mode status	Standard/Sports/Touring	Displays the status of steering mode based on the steering mode status signal transmitted by CAN communications.