Test Item

TEST ITEM	CONDITION	JUDGEMENT	CHECK ITEM (REMEDY)
ENG COOLANT TEMP	Engine: Return to the original trouble condition Change the engine coolant temperature using CONSULT.	If trouble symptom disappears, see CHECK ITEM.	Harness and connectors Engine coolant temperature sensor Fuel injector
FUEL INJECTION	Engine: Return to the original trouble condition Change the amount of fuel injection using CONSULT.	If trouble symptom disappears, see CHECK ITEM.	Harness and connectors Fuel injector Air fuel ratio (A/F) sensor 1
PURG VOL CONT/V	Engine: After warming up, run engine at 1, 500 RPM. Change the EVAP canister purge volume control solenoid valve opening percent using CONSULT.	Engine speed changes according to the opening percent.	Harness and connectors Solenoid valve
FUEL/T TEMP SEN	Change the fuel tank temperature using CONSULT.
POWER BALANCE	Engine: After warming up, idle the engine. A/C switch OFF Selector lever: P or N Cut off each injector signal one at a time using CONSULT.	Engine runs rough or dies.	Harness and connectors Compression Fuel injector Power transistor Spark plug Ignition coil
EXT V/T ASSIGN ANGLE	Engine: Return to the original non-standard condition Change exhaust valve timing using CONSULT.	If malfunctioning symptom disappears, see CHECK ITEM.	Harness and connectors Exhaust valve timing control solenoid valve
VENT CONTROL/V	Ignition switch: ON (Engine stopped) Turn solenoid valve ON and OFF with the CONSULT and listen to operating sound.	Solenoid valve makes an operating sound.	Harness and connectors Solenoid valve
FAN DUTY CONTROL *	Ignition switch: ON Change duty ratio using CONSULT.	Cooling fan speed changes.	Harness and connectors Cooling fan motor Cooling fan relay Cooling fan control module IPDM E/R
ALTERNATOR DUTY	Engine: Idle Change duty ratio using CONSULT.	Battery voltage changes.	Harness and connectors IPDM E/R Alternator
ACTIVE GRILLE SHUTTER	NOTE: Initial position learning is required every time when the Ignition Switch is turned OFF. Engine: Idle speed Touch "CALIBRTN" to perform initial position learning. Touch "OPEN" or "CLOSE" to operate active grille shutter.	Active grille shutter fully opens or fully closes.	Harness or connector Active grille shutter actuator Active grille shutter
FPCM	Engine: Return to the original trouble condition Select "LOW", "MID" and "HI" with CONSULT.	Fuel pump speed changes or stops.	Harness and connectors Fuel pump control module (FPCM)
IGNITION TIMING	Engine: Return to the original trouble condition Timing light: Set Retard the ignition timing using CONSULT.	If trouble symptom disappears, see CHECK ITEM.	Perform Idle Air Volume Learning.
WASTEGATE ACTUATOR	Ignition switch: ON Engine stopped Change valve of wastegate actuator target angle using CONSULT	Wastegate valve position sensor voltage changes according to valve target angle	Harness and connectors Electric wastegate control actuator (Removal bypass valve from turbocharger is NG) Turbocharger assembly
ENGINE OIL PRESSURE CONTROL SOLENOID VALVE	Water temperature: > - 10°C Engine oil temperature: < 120°C (248°F) Engine speed: < 4000 RPM	Engine oil pressure change	Harness and connectors Engine oil pressure control solenoid valve Engine oil pressure sensor Engine oil pump
Charge air cooler cooling electric water pump	Engine: Idle	Change the driving mode of charge air cooler cooling electric water pump.	Charge air cooler coolant temperature sensor Intake air temperature sensor Engine oil pressure sensor Charge air cooler cooling electric water pump 1, 2

* : Leaving cooling fan OFF with CONSULT while engine is running may cause the engine to overheat.