Diagnostic Test

1. Turn the ignition switch OFF.
2. Disconnect steering force control module harness connector and steering angle main control module harness connector.
3. Check the continuity between steering force control module harness connector and steering angle main control module harness connector.

   Steering force control module		Steering angle main control module		Continuity
   Connector	Terminal	Connector	Terminal
   M71	23	E26	23	Existed

Is the inspection result normal?

YES 

GO TO STEP 2  .

NO 

Repair or replace error - detected parts.

With CONSULT 

1. Connect steering force control module harness connector and steering angle main control module harness connector.
2. Turn the ignition switch ON.
3. On the CONSULT screen, select "DAST 1">>"DATA MONITOR">>"SUB IGN VOLTAGE".
4. Check the value

   Monitor item	Standard value (Approx.)
   SUB IGN VOLTAGE	Battery voltage

Is the inspection result normal?

YES 

GO TO STEP 3  .

NO 

Replace steering force control module. Refer to REMOVAL AND INSTALLATION .

With CONSULT 

1. Turn the ignition switch OFF.
2. Connect steering angle main control module harness connector.
3. Turn the ignition switch ON.
4. Erase self-diagnosis for "DAST 1".
5. Turn the ignition switch OFF and wait for at least 10 seconds.
6. Start the engine.
   CAUTION:

   Never drive the vehicle.

7. Perform self-diagnosis for "DAST 1".

Is DTC "C13BD - 00" detected?

YES 

Replace steering angle main control module. Refer to REMOVAL AND INSTALLATION .

NO 

• Check enlarged contact spring of terminal. Refer to HOW TO CHECK TERMINAL .
• Perform intermittent incident while turning steering wheel. Refer to INTERMITTENT INCIDENT .