Diagnostic Test

With CONSULT 

1. Turn the ignition switch ON.
2. Perform self-diagnosis for "ENGINE".

Is any DTC detected?

YES 

Check the DTC. Refer to DTC INDEX (Turbo high pressure model), DTC INDEX (Turbo low pressure model).

NO 

GO TO STEP 2  .

With CONSULT 

1. Turn the ignition switch ON.
2. Erase self - diagnosis for "EPS/DAST 3".
3. Turn the ignition switch OFF and wait for at least 10 seconds.
4. Turn the ignition switch ON.
5. Perform self-diagnosis for "EPS/DAST 3".

Is DTC "C13CA - 00" detected?

YES 

GO TO STEP 3  .

NO 

• Check enlarged contact spring of terminal. Refer to HOW TO CHECK TERMINAL .
• Perform intermittent incident while turning steering wheel. Refer to INTERMITTENT INCIDENT .

1. Turn the ignition switch OFF.
2. Disconnect steering force control module harness connector and then check steering force control module pin terminals for damage or loose connection with harness connector.
3. Disconnect ECM harness connector and then check ECM pin terminals for damage or loose connection with harness connector.

Is the inspection result normal?

YES 

Replace steering force control module. Refer to REMOVAL AND INSTALLATION .

NO 

Repair or replace error - detected part.