Diagnosis Procedure

1. Turn ignition switch OFF.
2. Check that the following fuse is not blown (open).

   Power source	Fuse No.	Capacity
   Ignition switch ON	#93	5 A

Is the fuse blown (open)?

YES 

Replace fuse after repairing the applicable circuit.

NO 

GO TO STEP 2  .

1. Turn ignition switch ON.
2. Check the voltage between around view monitor control unit harness connector and ground.

Is the inspection result normal?

YES 

GO TO STEP 3  .

NO 

Perform trouble diagnosis of ignition power supply circuit.

1. Turn ignition switch OFF.
2. Disconnect around view monitor control unit connector.
3. Check the continuity between around view monitor control unit harness connector and ground.

   (+)		(-)	Continuity
   Around view monitor control unit
   Connector	Terminal
   M8	39	Ground	Existed

Is the inspection result normal?

YES 

INSPECTION END

NO 

Repair or replace harness or connector.