Work Procedure
- SAVING VEHICLE SPECIFICATION
CONSULT Configuration
Perform "Before Replace ECU", and save the current vehicle specification in CONSULT.
Is the vehicle specification saved normally?
YES
GO TO STEP 2 .
NO
GO TO STEP 4 .
- REPLACE AROUND VIEW MONITOR CONTROL UNIT
Replace around view monitor control unit. Refer to REMOVAL AND INSTALLATION .
GO TO STEP 3 .
- WRITING VEHICLE SPECIFICATION
Select "Configuration" or "After Replace ECU", and write the vehicle specification saved in CONSULT to around view monitor control unit.
GO TO STEP 6 .
- REPLACE AROUND VIEW MONITOR CONTROL UNIT
Replace around view monitor control unit. Refer to REMOVAL AND INSTALLATION .
GO TO STEP 5 .
- WRITE VEHICLE SPECIFICATION
Select "Manual Configuration", and write the setting value as shown in the following table to around view monitor control unit according to the vehicle specification.
CAUTION:- Grasp vehicle specifications precisely. The control of ECU may not function normally if the specifications are misread.
- Do not perform any operation such as the navigation operation during configuration writing.
NOTE:- The items shown in this list depend on vehicle specifications.
- The config list may not be displayed depending on vehicle specifications. This is not a malfunction.
- If selection items are not displayed on the CONSULT screen, touch "NEXT".
MANUAL SETTING ITEM Detail Items Setting value HANDLE LHD LHD models RHD RHD models TRANSMISSION AT/CVT A/T models MT M/T models GO TO STEP 6 .
- PERFORM SELF-DIAGNOSIS
Perform self-diagnosis of CONSULT, and check whether or not DTC U1305 is detected.
Is DTC U1305 detected?
YES
GO TO STEP 5 .
NO
GO TO STEP 7 .
- OPERATION CHECK
Check that the operation of the around view monitor control unit and camera images (fixed guide lines and predictive course lines) are normal.
WORK END