Set Condition

Under a standby state, pushing down the SET/COAST switch will start system control.

When vehicle speed is between approximately 32 km/h and 144 km/h (20 MPH and 90 MPH).
When vehicle speed is below approximately 32 km/h (20 MPH) if the vehicle ahead is detected. The set vehicle speed becomes 32 km/h (20 MPH).

If the system is canceled by conditions 1 - 6 below, the system will resume control at the last set cruising speed by pushing up the RESUME/ACCELERATE switch.

NOTE:

When the SET/COAST switch is pushed under the following conditions, the system cannot be set and the set vehicle speed indicator will blink for approximately 2 seconds.

Courtesy of NISSAN NORTH AMERICA, INC.

When traveling below 32 km/h (20 MPH) and the vehicle ahead is not detected.
When the selector lever is not in the "D", "DS" position or manual mode.
When the front wipers are operating at LO or HI.
When the parking brakes are applied.
When the brakes are operated by the driver.

When the SET/COAST switch is pushed under the following conditions, the system cannot be set. A warning chime will sound and the set speed indicator and own vehicle indicator will blink.

Courtesy of NISSAN NORTH AMERICA, INC.

When the snow mode switch is ON. (To use the ICC system, turn OFF the snow mode switch, push the MAIN switch to turn OFF the ICC system and reset the ICC system by pushing the MAIN switch again.)
When the VDC is OFF. (To use the ICC system, turn ON the VDC system, push the MAIN switch to turn OFF the ICC system and reset the ICC system by pushing the MAIN switch again.)
When ABS or VDC (including the TCS) operates.
When driving into a strong light (i.e., sunlight).
When the wheel is slipping (To use the ICC system, make sure the wheels are no longer spinning, push the MAIN switch to turn OFF the ICC system and reset the ICC system by pushing the MAIN switch again.)