LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Infiniti >> 2017 >> QX60 Base, FWD >> Repair and Diagnosis (Single Page) >> Engine Performance >> Testing & Diagnosis >> Engine Control System (DTC/Circuit Diagnosis, Symptom Diagnosis & Removal And Installation) (Except Hybrid) >> DTC/Circuit Diagnosis >> Brake Pedal Position Switch >> Component Function Check >> Diagnostic Test
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Diagnostic Test

  1. CHECK BRAKE PEDAL POSITION SWITCH FUNCTION

    G-20With CONSULT 

    1. Turn ignition switch ON.
    2. On CONSULT screen, select "ENGINE">>"Data Monitor">>"BRAKE SW1".
    3. Check "BRAKE SW1" indication under the following conditions.
      Monitor item Condition Indication
      BRAKE SW1 Brake pedal Slightly depressed OFF
      Fully released ON

    G-21Without CONSULT 

    1. Turn ignition switch ON.
    2. Check the voltage between ECM harness connector terminals as per the following.
      ECM Condition Voltage
      (Approx.)
      Connector + -
      Terminal
      E32 192
      (Brake pedal position switch signal)      		 204 Brake pedal Slightly depressed 0 V
      Fully released Battery voltage

    Is the inspection result normal?

    YES 

    INSPECTION END

    NO 

    Proceed to DIAGNOSIS PROCEDURE .

scientia non olet · About LEMON Manuals