Test Item

TEST ITEM	CONDITION	JUDGEMENT	CHECK ITEM (REMEDY)
FUEL INJECTION	Engine: Return to the original trouble condition Change the amount of fuel injection using CONSULT.	If trouble symptom disappears, see CHECK ITEM.	Harness and connectors Fuel injector Air fuel ratio (A/F) sensor 1
ENG COOLANT TEMP	Engine: Return to the original trouble condition Change the engine coolant temperature using CONSULT.	If trouble symptom disappears, see CHECK ITEM.	Harness and connectors Engine coolant temperature sensor Fuel injector
PURG VOL CONT/V	Engine: After warming up, run engine at 1, 500 RPM. Change the EVAP canister purge volume control solenoid valve opening percent using CONSULT.	Engine speed changes according to the opening percent.	Harness and connectors Solenoid valve
FUEL/T TEMP SEN	Change the fuel tank temperature using CONSULT.
TUMBLE CONTROL VALVE	Ignition switch: ON Turn intake manifold runner control valve "ON" and "OFF" using CONSULT and listen to operating sound.	Intake Manifold Runner control valve motor makes an operating sound.	Harness and connectors Intake Manifold Runner control valve motor
IGNITION TIMING	Engine: Return to the original trouble condition Timing light: Set Retard the ignition timing using CONSULT.	If trouble symptom disappears, see CHECK ITEM.	Perform Idle Air Volume Learning.
POWER BALANCE	Engine: After warming up, idle the engine. A/C switch OFF Selector lever: P Cut off each injector signal one at a time using CONSULT.	Engine runs rough or dies.	Harness and connectors Compression Fuel injector Power transistor Spark plug Ignition coil
VENT CONTROL/V	Ignition switch: ON (Engine stopped) Turn solenoid valve ON and OFF with the CONSULT and listen to operating sound.	Solenoid valve makes an operating sound.	Harness and connectors Solenoid valve
INT V/T ASSIGN ANGLE	Engine: Return to the original non-standard condition Change intake valve timing using CONSULT.	If malfunctioning symptom disappears, see CHECK ITEM.	Harness and connectors Intake valve timing control solenoid valve
EXH V/T ASSIGN ANGLE	Engine: Return to the original non-standard condition Change exhaust valve timing using CONSULT.	If malfunctioning symptom disappears, see CHECK ITEM.	Harness and connectors Exhaust valve timing control solenoid valve
TC/SC BYPASS VALVE	Ignition switch: ON (Engine stopped) The supercharger bypass valve is opened/closed.	The supercharger bypass valve angle changes according to set value.	Harness and connectors SCB valve control actuator
FUEL PUMP CONTROL MODULE	Ignition switch: ON (Engine stopped) Selector lever: P position Turn fuel pump ON and OFF with the CONSULT and listen to operating sound.	Fuel pump makes an operating sound.	Harness and connectors Fuel pump control module (FPCM) Fuel pump

* : Leaving cooling fan OFF with CONSULT while engine is running may cause the engine to overheat.