Diagnostic Test
- CHECK SNOW MODE SWITCH-I
- Turn Ignition Switch OFF.
- Disconnect snow mode switch harness connector.
- Check the continuity between snow mode switch terminals under the following conditions.
Terminals Condition Continuity 1 and 4 Snow mode switch ON Existed OFF Not Existed
Is the inspection result normal?
YES
GO TO STEP 2 .
NO
Replace snow mode switch. Refer to COMPONENT LOCATION .
- CHECK SNOW MODE SWITCH-II
Check the continuity between snow mode switch terminals under the following conditions.
Terminals (Polarity) Continuity 2 (+) - 4 (-) Existed 4 (+) - 2 (-) Not Existed Is the inspection result normal?
YES
INSPECTION END
NO
Replace snow mode switch. Refer to COMPONENT LOCATION .