LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Infiniti >> 2017 >> QX80 Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 171 (Driver Assistance System (Introduction)) >> Ecu Diagnosis Information >> ICC Sensor >> Reference Value >> Values On The Diagnosis Tool
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Values On The Diagnosis Tool

WARNING: This page is about a different car, the 2016 Infiniti QX80. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

The following table includes information (items) inapplicable to this vehicle. For information (items) applicable to this vehicle, refer to CONSULT display items.

Monitor item Condition Value/Status
VHCL SPEED SE While driving Value of vehicle speed signal (wheel speed)
YAW RATE While driving Vehicle stopped 0.0
Vehicle turning right Positive value
Vehicle turning left Negative value
PWR SUP MONI Ignition switch ON Power supply voltage value of ICC sensor
DISTANCE Drive the vehicle and activate the vehicle-to-vehicle distance control mode When a vehicle ahead is detected Displays the distance from the preceding vehicle
When a vehicle ahead is not detected 0.0
RELATIVE SPD Drive the vehicle and activate the vehicle-to-vehicle distance control mode When a vehicle ahead is detected Displays the relative speed
When a vehicle ahead is not detected 0.0
RADAR OFFSET
NOTE:

The item is displayed, but not used

-
RADAR HEIGHT
NOTE:

The item is displayed, but not used

-
STEERING ANGLE Ignition switch ON When setting the steering wheel in straight-ahead position 0.0
When turning the steering wheel 90° rightward +90
When turning the steering wheel 90° leftward -90
STRG ANGLE SPEED Ignition switch ON At the time of turning the steering wheel Steering wheel turning speed is displayed
L/R ADJUST Ignition switch ON At the completion of radar alignment adjustment Horizontal correction value is displayed
U/D ADJUST Ignition switch ON At the completion of radar alignment adjustment Vertical correction value is displayed