LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Infiniti >> 2017 >> QX80 Base, RWD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Communication Devices >> Body Control System (Introduction, Wiring Diagrams And Basic Inspection) >> System Description >> System >> Body Control System >> Fail-Safe >> Fail-Safe Control By DTC
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Fail-Safe Control By DTC

BCM performs fail-safe control when any DTC are detected.

Display contents of CONSULT Fail - safe Cancellation
B2192: ID DISCORD BCM-ECM Inhibit engine cranking Erase DTC
B2193: CHAIN OF BCM-ECM Inhibit engine cranking Erase DTC
B2195: ANTI-SCANNING Inhibit engine cranking Ignition switch ON → OFF
B2198: NATS ANTENNA AMP Inhibit engine cranking Erase DTC
B2608: STARTER RELAY Inhibit engine cranking 500 ms after the following signal communication status becomes consistent
  • Starter motor relay control signal
  • Starter relay status signal (CAN)
B260F: ENG STATE SIG LOST Inhibit engine cranking When any of the following conditions are fulfilled
  • Power position changes to ACC
  • Receives engine status signal (CAN)
B261B: RES ENG RUN STUCK MALFUNC Fuel cut When engine status signal (CAN) is received normally
B26F1: IGN RELAY OFF Inhibit engine cranking When the following conditions are fulfilled
  • Ignition switch ON signal (CAN: Transmitted from BCM): ON
  • Ignition switch ON signal (CAN: Transmitted from IPDM E/R): ON
B26F2: IGN RELAY ON Inhibit engine cranking When the following conditions are fulfilled
  • Ignition switch ON signal (CAN: Transmitted from BCM): OFF
  • Ignition switch ON signal (CAN: Transmitted from IPDM E/R): OFF
B26F3: START CONT RLY ON Inhibit engine cranking When the following conditions are fulfilled
  • Starter control relay signal (CAN: Transmitted from BCM): OFF
  • Starter control relay signal (CAN: Transmitted from IPDM E/R): OFF
B26F4: START CONT RLY OFF Inhibit engine cranking When the following conditions are fulfilled
  • Starter control relay signal (CAN: Transmitted from BCM): ON
  • Starter control relay signal (CAN: Transmitted from IPDM E/R): ON
B26F7: BCM Inhibit engine cranking by Intelligent Key system When room antenna and luggage room antenna functions normally
B26FE: HOOD SW CAN DIAG ERROR Inhibit remote engine start When the following conditions are fulfilled
  • Power position ON
  • Hood switch signal (CAN) is received normally
scientia non olet · About LEMON Manuals