Diagnostic Test
- CHECK THROTTLE POSITION SENSOR
- Turn ignition switch OFF.
- Reconnect all harness connectors disconnected.
- Perform DESCRIPTION .
- Turn ignition switch ON.
- Set selector lever position to D.
- Check the voltage between ECM harness connector terminals under the following conditions.
ECM Condition Voltage (V) Connector + - Terminal Terminal F92 78
(TP sensor 1 signal)85
(Sensor ground)Accelerator pedal Fully released More than 0.36 Fully depressed Less than 4.75 80
(TP sensor 2 signal)Fully released Less than 4.75 Fully depressed More than 0.36
Is the inspection result normal?
YES
INSPECTION END
NO
GO TO STEP 2 .
- REPLACE ELECTRIC THROTTLE CONTROL ACTUATOR
Replace electric throttle control actuator. Refer to REMOVAL AND INSTALLATION .
INSPECTION END