Work Procedure: FPCM

With CONSULT

1. Turn ignition switch ON.
2. Select the "Re/programming, Configuration" of CONSULT.
3. Perform configuration according to the CONSULT display.

GO TO 2 .

CONSULT Configuration

Select "CONFIGURATION" of FSCM.

When writing saved data

GO TO 3 .

CONSULT Configuration

Select "Before ECU Replacement". (If necessary)

GO TO 4 .

CONSULT Configuration

Perform "Before ECU Replacement" according to the CONSULT display. (If necessary)

GO TO 5 .

With CONSULT

1. Turn ignition switch ON.
2. Select the "Re/programming, Configuration" of CONSULT.
3. Select the "After ECU Replacement".
4. Select the "Manual Configuration". (If necessary)
5. Confirm and/or change setting value for each item.
6. Perform configuration according to the CONSULT display.

GO TO 6 .

With CONSULT

1. Turn ignition switch OFF and wait for 10 seconds or more.
2. Turn ignition switch ON.
3. Perform self-diagnosis.
4. Check that no DTC is detected.

WORK END