Consult Data Monitor Standard Value
|
Monitor item |
Condition |
Reference values in normal operation |
|
FR LH SENSOR |
Vehicle stopped |
0.00 km/h (MPH) |
|
When driving(Note 1) |
Nearly matches the speedometer display (within +/-10%) |
|
|
FR RH SENSOR |
Vehicle stopped |
0.00 km/h (MPH) |
|
When driving(Note 1) |
Nearly matches the speedometer display (within +/-10%) |
|
|
RR LH SENSOR |
Vehicle stopped |
0.00 km/h (MPH) |
|
When driving(Note 1) |
Nearly matches the speedometer display (within +/-10%) |
|
|
RR RH SENSOR |
Vehicle stopped |
0.00 km/h (MPH) |
|
When driving(Note 1) |
Nearly matches the speedometer display (within +/-10%) |
|
|
BATTERY VOLT |
Ignition switch ON |
10 - 16 V |
|
STOP LAMP SW |
Brake pedal depressed |
On |
|
Brake pedal not depressed |
Off |
|
|
YAW RATE SEN |
Vehicle stopped |
Approx. 0 d/s |
|
Turning right |
Negative value |
|
|
Turning left |
Positive value |
|
|
FR RH IN SOL |
Active |
On |
|
Not activated |
Off |
|
|
FR RH OUT SOL |
Active |
On |
|
Not activated |
Off |
|
|
FR LH IN SOL |
Active |
On |
|
Not activated |
Off |
|
|
FR LH OUT SOL |
Active |
On |
|
Not activated |
Off |
|
|
RR RH IN SOL |
Active |
On |
|
Not activated |
Off |
|
|
RR RH OUT SOL |
Active |
On |
|
Not activated |
Off |
|
|
RR LH IN SOL |
Active |
On |
|
Not activated |
Off |
|
|
RR LH OUT SOL |
Active |
On |
|
Not activated |
Off |
|
|
MOTOR RELAY |
Active |
On |
|
Not activated |
Off |
|
|
ACTUATOR RLY |
Active |
On |
|
When not operating (in fail-safe mode) |
Off |
|
|
ABS WARN LAMP |
When ABS warning lamp is ON(Note 2) |
On |
|
When ABS warning lamp is OFF(Note 2) |
Off |
|
|
OFF LAMP |
When VDC OFF indicator lamp is ON(Note 2) |
On |
|
When VDC OFF indicator lamp is OFF(Note 2) |
Off |
|
|
SLIP/VDC LAMP |
When VDC warning lamp is ON(Note 2) |
On |
|
When VDC warning lamp is OFF(Note 2) |
Off |
|
|
ACCEL POS SIG |
Never depress accelerator pedal (with ignition switch ON) |
0% |
|
Depress accelerator pedal (with ignition switch ON) |
0 - 100% |
|
|
SIDE G-SENSOR |
Vehicle stopped |
Approx. 0 m/s2 |
|
Right turn |
Negative value |
|
|
Left turn |
Positive value |
|
|
DECEL G-SEN |
When stopped |
Approx. 0 G |
|
During acceleration |
Positive value |
|
|
During deceleration |
Negative value |
|
|
STR ANGLE SIG |
When driving straight |
0+/-2.5 deg. |
|
When steering wheel is steered to RH by 90 deg. |
Approx. +90 deg. |
|
|
When steering wheel is steered to LH by 90 deg. |
Approx. -90 deg. |
|
|
ENGINE SPEED |
Engine stopped |
0 rpm |
|
Engine running |
Almost same reading as tachometer |
|
|
PRESS SENSOR |
Brake pedal not depressed |
Approx. 0 bar |
|
Brake pedal depressed |
0 - 255 bar (Pressure increases according to pedal effort.) |
|
|
FLUID LEV SW |
When brake fluid level switch is ON (brake fluid level is less than the specified level) |
On |
|
When brake fluid level switch is OFF |
Off |
|
|
PARK BRAKE SW |
When parking brake is active |
On |
|
Parking brake is released |
Off |
|
|
CV1 |
Active |
On |
|
Not activated |
Off |
|
|
CV2 |
Active |
On |
|
Not activated |
Off |
|
|
EBD SIGNAL |
EBD activated |
On |
|
EBD not activated |
Off |
|
|
ABS SIGNAL |
ABS is activated |
On |
|
ABS is not activated |
Off |
|
|
TCS SIGNAL |
TCS activated |
On |
|
TCS not activated |
Off |
|
|
VDC SIGNAL |
VDC activated |
On |
|
VDC not activated |
Off |
|
|
EBD FAIL SIG |
In EBD fail-safe |
On |
|
EBD is normal |
Off |
|
|
ABS FAIL SIG |
In ABS fail-safe |
On |
|
ABS is normal |
Off |
|
|
TCS FAIL SIG |
In TCS fail-safe |
On |
|
TCS is normal |
Off |
|
|
VDC FAIL SIG |
In VDC fail-safe |
On |
|
VDC is normal |
Off |
|
|
CRANKING SIG |
At cranking |
On |
|
Other than at cranking |
Off |
|
|
EBD WARN LAMP |
When brake warning lamp is ON(Note 2) |
On |
|
When brake warning lamp is OFF(Note 2) |
Off |
|
|
GEAR |
Driving |
1 - 7 Depending on shift status |
|
N POSI SIG |
When selector lever is in the N position |
On |
|
When selector lever is in the other position than N |
Off |
|
|
R POSI SIG |
When selector lever is in the R position |
On |
|
When selector lever is in the other position than R |
Off |
|
|
4WD MODE MON(Note 3) |
Always |
AUTO, LOCK, 2WD (depending on AWD control status) |
|
VDC control mode(Note 4) |
When drive mode select switch is the Sport+ |
Sports |
|
When drive mode select switch is NOT Sport+ |
Standard |
|
|
USS SIG(Note 5) |
When hill start assist is active |
On |
|
When hill start assist is not active |
Off |
Note 1: Confirm tire pressure is standard value.
Note 2: Refer to System Description for ON/OFF conditions of each warning lamp and indicator lamp.
Note 3: AWD models
Note 4: VR30DDTT engine models
Note 5: "USS" means "hill start assist"