Values On The Diagnosis Tool

NOTE: The following table includes information (items) inapplicable to this vehicle. For information (items) applicable to this vehicle, refer to CONSULT display items.

Monitor item	Data monitor
	Condition		Display value
BATTERY VOLT	Engine running		Battery voltage (V)
AUTO STOP START FLAG	Engine running	No steering wheel operation	OK
		Steering wheel operation	NG
AUTO STOP START STATUS	During stop/start system operation		On
	Restart (engine cranking)		CRANK
	Engine running		Off
Idle Stop Act	Stop/start system is active		On
	Stop/start system is not active		Off
STEERING MODE	Steering mode: Standard		NORML
	Steering mode: Sport		SPORT
STEERING ANGLE	The steering wheel is not steered.		Approx. 0.0 deg
	The steering wheel is steered.		Displays steering angle speed (deg)
STR ANG SPD	The steering wheel is not steered.		Approx. 0.0 deg/s
	The steering wheel is steered.		Displays steering angle speed (deg/s)
MOTOR CURRENT	Engine running	Steering wheel: Not steering (There is no steering force)	MAX approx. 10 A ^*1
		Steering wheel: Right or left turn	Displays consumption current of power steering control module (A)
MTR REV SPD COMM	Engine running	Steering wheel: Not steering (There is no steering force)	Shows an almost constant value (rpm)
		Steering wheel: Right or left turn	The value changes as a steering speed (rpm)
MTR REV SPD	Engine running	Steering wheel: Not steering (There is no steering force)	Shows an almost constant value (rpm) ^*2
		Steering wheel: Right or left turn	The value changes as a steering speed (rpm) ^*2
C/U TEMP	Engine running		Displays temperature of inside of power steering control module (deg.C or deg.F)
C/U TEMP A	Engine running		Displays temperature of inside of power steering control module (deg.C or deg.F)
MTR ASSIST	Engine running		100% ^*3
ESTM VHCL SPD	Vehicle stopped		0.00 km/h or mph
	While driving		Approximately equal to the indication on speedometer ^*4 (inside of +/-10%)
WARNING LAMP	Power steering warning lamp: ON		On
	Power steering warning lamp: OFF		Off
ENGINE STATUS	Engine not running		STOP
	Engine running		RUN
	Engine cranking		CRANK
VHCL SPD JUDGE	Vehicle speed signal can be received via CAN communication		OK
	Vehicle speed signal cannot be received via CAN communication		NG

*1: The value changes according to load of power steering motor.

*2: This is in close agreement with a motor speed command value. Although a quick steering operation may cause disagreement, this is not a malfunction.

*3: Usually, 100% is displayed. An excessive steering operation gradually lowers the percentage. When left standing, the percentage returns to 100%.

*4: This may not agree with the speedometer indication immediately after the ignition switch is turned ON. This is not a malfunction.